Remotec Z-URC550 V1 User Manual download pdf (Page 36)

5 Press a desired key once and release on the Z-URC

550EU

which you want to learn the command. The green indicator will

flash once then stay lit.

6 Press and keep holding the key on your original equipment remote

which you want to learn for a few seconds.

7 When the green indicator light flashes twice and stays lit

continuously, the command has been learned successfully and you

can release the key on your original equipment remote. If the red

indicator light flashes six times, it shows an error in the learning

process. Adjust the position of both remotes and repeat from step 5

again.

8 Repeat from step 5 to learn other key functions, or press the same

device mode key on step 1 (e.g. TV) to terminate the learning

mode, the green indicator light will flash twice and then go out

immediately.

Notes:

− On step 5 if no key is selected for more that 8 seconds, the red

indicator light will flash six times and the learning mode will exit

automatically.

− On step 6, if no other remote signal is received for more than 8

seconds, the red indicator light flashes six times and stays lit

continuously, you need to select a desired key again for learning

as in step 5 on your Z-URC

550EU.

− Each function key will hold one command only, a new command to

be learned will automatically erase and replace the previous one.

− If the green indicator light flashes six times during the

transference of signals, the maximum of 100 commands memory

bank is full, press the same device key again to resume normal

operation.

− All device mode keys, as well as the SHIFT keys cannot be used for

learning functions.

Operating the Z-URC

550EU for AV Equipment

Normal Operation

Once you have setup the Z-URC

550EU for your AV equipment, it

works like your original remote control. To operate, just aim it at your

equipment, press an appropriate device mode key and invoke the

desired function by pressing a corresponding key on the Z-URC

550EU. The green indicator turns on during signal transmission and as

Confirmation of key touch.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43 44

No comments

Remotec Z-URC550 V1 User Manual Page 36