Remotec ZTS-110 V3.12 User Manual download pdf (Page 5)

Glossary

Devices and nodes are all terms to describe an individual Z-Wave

device. These are all interchangeable when setting up your Z-Wave

network.

Device or Node

Inclusion

Add a Z-Wave device to the network.

Exclusion

Delete a Z-Wave device from the network.

Remove

To take a device out of a group, scene or association group while that

device still exists in the same Z-Wave network.

Network Wide

Inclusion (NWI)

Network Wide Inclusion (NWI) enables both end-user friendly, Plug

and Play like Z-Wave network installation as well as professional

installation scenario where the inclusion process in terms of time will

be reduced significantly. NWI is a feature supported by a new frame

type named Explorer which enables the Z-Wave protocol to implement

Adaptive Source Routing.

Z-Wave

Network

A collection of Z-Wave devices is controlled by primary and secondary

controllers operating on the same system. A Z-Wave network has its

own unique ID code so that controllers not in the network cannot

control the system.

Primary

Controller

The first controller is used to set up your devices and network. Only

the Primary Controller can be used to include or delete devices from a

network. It is recommended that you mark the primary controller for

each network for ease in modifying your network.

FLiRS Mode

FLiRS is abbreviation for "Frequently Listening Routing Slave".

FLiRS mode is targeted for battery operated applications and will enter

sleep mode frequently in order to conserve battery consumption. The

response to Z-Wave command is not as quick as Always Listening

Device. Normally there is 1-2 seconds latency.

Always

Listening Mode

Always Listening mode is targeted for AC power operated applications

and it can act as a repeater, which will re-transmit the RF signal to

ensure that the signal is received by its intended destination by routing

the signal around obstacle and radio dead spots. The response to

Z-Wave command is immediate.

Association

Association is used to organize nodes in different groups allowing the

device to identify the nodes by a group identifier. The groups can also

be copied to other devices.

1 2 3 4 5 6 7 8 9 10 ... 39 40

Comments to this Manuals

No comments

Remotec ZTS-110 V3.12 User Manual Page 5

Comments to this Manuals

Related products and manuals for Remote control Remotec ZTS-110 V3.12